One Room Challenge – Rustic Modern Office Space – Week Three

OK! Here we are again…week three is already upon us! If you’re new here, let me fill you in on what’s going on! I am totally redesigning an office space/outdoor shed for my husband, who works from home, as part of the One Room Challenge. If you would like to catch up in order, here’s a link to Week One and Week Two. Once again, here’s a looky at my vision or plan for the space.

So this week was all about paints and stains. I needed to make a choice for a treatment for the floors ( 1×6 pine boards) and I have been planning on a moody accent wall since we began envisioning the space. I needed a rich, dark color and after looking at 975,873,489 black(ish) paint swatches, I landed on Black Jack by Benjamin Moore. Here’s the wall for which the paint was intended.

The sofa that is going to be sitting against this wall is a butterscotch color and I’m so excited to see it just POP against this moody color. In fact, I just recieved word today that the sofa is shipping out in the next few days….someone pinch me!

I have painted lots of walls during the course of my diy adventures, but painting wood paneling is no joke. Getting the paint between the boards is a time sucker. Also, a tip that I thought I would share would be, that if you’re planning on painting paneling a dark color, paint the wall behind in a dark shade before you install the wood. This way, any cracks that are visible when you finish installing, are already dark in color. Mmmmmmkay??  Out of the three previous photos, the third one most accurately represents the color in real life. And of course, I went with a matte finish because I just can’t ever get enough of that velvety finish.

Next up was choosing the stain and polyurethane for the floors. I mentioned this in my last post but a very wise reader wrote and warned me that if I didn’t use some kind of stain, then the floors would eventually darken and yellow. A look that I am trying to avoid.

When I found this antique white by Varathane, I knew I had found what I was looking for. It gave the floors a very bright white look but didn’t cover any of the wood grain or knots.

I applied the first coat of polyurethane just this afternoon and am still undecided about how many coats I should do. I will probably do at least one more for good measure. It is pine which means it’s a very soft wood, so we need maximum protection.

Finally, I liked the color that I used on the accent wall inside so much, that I may just use it for the exterior too. I tested a spot and me likey…

But we’ll save that discussion for next week! See ya in a week! Oh…and if you have any questions for me….don’t be shy! Leave me a comment below! XO

Thank you so much for reading! XX Courtney

You may also like

9 comments

  1. I am loving every one of your color choices! I’d go with an extra coat on the floor. Just because you’re going to be walking on it and really using it. I can’t wait until you get to start the final touches!